Hugo. 1995 UKDM BB1 track hack

chrismc · Post by **chrismc** » Fri Jan 16, 2015 10:26 pm

http://youtu.be/ttGXdJv8eNY

Dyno run!

Jdm ecu & spoon copy chip
JAPspeed mani & modded downpipe (2.5" collector)
JAPSPEED resonated decat
Fujitsubo Legalis R system
K&N typhoon intake

206bhp/153lbs/ft

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Sat Jan 17, 2015 9:15 am

For an h22a2? That's pretty good.
how comes using a Jdm ecu rather than chipping a Ukdm ecu?

chrismc · Post by **chrismc** » Sat Jan 17, 2015 10:28 am

wurlycorner wrote:For an h22a2? That's pretty good.
how comes using a Jdm ecu rather than chipping a Ukdm ecu?

Yes it's an A2. Responded well to the mods!

I don't think the UKDM ecu is chippable- whereas I bought the JDM ECU socketed then bought one of the Spoon copy chips from Rob on here. Straight swap.

Tried the Rev limited & non limited versions. No discernible difference in power

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Sat Jan 17, 2015 1:56 pm

You can chip some Ukdm ecu's, depends on the particular model number of your ecu IIRC (the one in my Ukdm can and will eventually get be chipped!).

I thought running a Jdm ecu on an a2 was a bad idea because firstly it's tuned for a different compression engine and secondly it will be looking for a knock sensor (which it won't find)?

Do I have that wrong?

chrismc · Post by **chrismc** » Sat Jan 17, 2015 3:12 pm

Mine runs spot on with the JDM. I was worried about the difference in CR from h22a to a2 but it runs great

CEL illuminates after a few miles but as its a track car it's no drama.

I just make sure not to be greedy with ign timing

Lude Generation

Hugo. 1995 UKDM BB1 track hack

Hugo. 1995 UKDM BB1 track hack

Re: Hugo. 1995 UKDM BB1 track hack

Re: Hugo. 1995 UKDM BB1 track hack