Prelude Remapped chips-JDM Spoon V2 Auto/Manual+UKDM+Chrome+

Kie39 · Post by **Kie39** » Sun Feb 07, 2016 3:44 pm

4thgenphil wrote:The 4 plug one is a tcs ecu, you can use the 3 plug on just have to change a wire over to feed the speedo.

Not sure I explained myself properly, the one with three plugs we already use but don't want to chip this one. Will the four plug ECU work with only 3 connections?

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Sun Feb 07, 2016 9:22 pm

Probably yes, but you have to drokk around with the wiring loom on the car and it will probably put the eml on.
Or, it might not work at all and just strangle power all the time (tcs kicking in cause it doesn't receive all the signals it needs).
I'll swap you that 4 pin tcs for a 3pin non-tcs ecu for you to modify if you like and if I have the right one on the shelf.

What ecu code did you buy the chip for? (He sells different chips for different ecu codes)

Supercharged 無限MUGEN BB1 Profile · Post by **nucleustylzlude** » Tue Feb 09, 2016 8:55 pm

Don't worry Iain, those ECU's are both JDM P13's - J00 & N00 (both the same code and map). So my Spoon chips will work on either.

But the practical side of running the 3 plug in lieu of the 4 plug which is merely down to the traction control system (TCS), someone will have to clarify the wiring for all other things to work - speedo and no warning lights to come on - sounds like @4thgenphil knows a bit about this...?

@Kie39: Sounds like a simple swap with @wurlycorner above would be helpful.

Cheers,

Rob

Post by **Vtecmec** » Wed Feb 10, 2016 9:46 am

I've run a four plug ecu in a 3 plug car.. No issues, the car will show a code (tcs fault) if you check for any, but no running issues or eml on the dash.

Post by **4thgenphil** » Wed Feb 10, 2016 3:16 pm

Vtecmec wrote:I've run a four plug ecu in a 3 plug car.. No issues, the car will show a code (tcs fault) if you check for any, but no running issues or eml on the dash.

Does the speedo work?

Kie39 · Post by **Kie39** » Sun Feb 14, 2016 6:39 pm

Thanks for the info guys!

Think we're gonna try the four plug ECU and see how it goes. Will let you know if it has any issues.

Out of interest if we want to just remove limiter on the other ECU how's oils we do that?

Post by **Vtecmec** » Sun Feb 14, 2016 7:09 pm

4thgenphil wrote:Does the speedo work?

It did, no problems at all.

Kie39 · Post by **Kie39** » Thu Feb 25, 2016 1:04 pm

Ok! so the four plug ECU did not work. Car starts fine but zero throttle response.

Looks like were back to where we started!

@wurlycorner If you have a spare 3 plug ECU are you still interested in a swap???

Supercharged 無限MUGEN BB1 Profile · Post by **nucleustylzlude** » Thu Feb 25, 2016 5:12 pm

Vtecmec wrote:
4thgenphil wrote:Does the speedo work?
It did, no problems at all.

You lie boy!

Supercharged 無限MUGEN BB1 Profile · Post by **nucleustylzlude** » Thu Feb 25, 2016 5:13 pm

Something is amiss there then. Sounds like that swap with Iain is a clean solution.