Things you will need:
10mm socket
Rachet
Extention bar
Pozi screwdriver
80 Grit sand paper
Silicon lubricant or WD40
A Tube of Sikoflex/ Glass bonding silicone sold at halfords
First off remove the door card
Then position the runner where you can caccess the window clips, the runner actually slides left and right so you can position them where you like
Carefully remove the glass and take it somewhere flat to work on, clean the previous adehsive off and sand to give the new adehsive something to stick to, i used 80 grit decorators sandpaper
Then clean the gunk out of the clips
Lube the rubber runners, try to get right in the back, silicon lubricant works best but i didnt have any lol
Then fill the clips up with the sikoflex/window bonding sealant (be VERY carefull with this stuff it wont come out of clothes or fabric!)
Bolt them back in
Then raise the runner to about here
And carefully lower the glass back in making sure its correctly seated in both clips
Then wind the window right up making sure its all correctly aligned and leave for a couple of days, avoid Mcdonalds drivethru also
