Fujitsubo mani information(maybe others re wrap section)

[newkid]

This info is for fujitsubo mani/downpipe, wrap section may be useful for others.

wurlycorner cant pm. So here’s the info for you and others.

Clamp bracket goes In same place as in pic, helps strengthen the downpipe. One I sent is bb1/4 one and bolts to the little bracket you will see on engine when you look. Mine bolts up differently as it’s a cl1. So pic is just a helper.



Also there’s 3 parts in the bay that are to be wrapped with exhaust wrap, presume because it’s stainless and no heat shield as per pic



Water pipe, air con pipe and wiring to alternator, this was a later update so don’t think anyone has done it, even I haven’t yet but I will be.

O btw. Parts are on me

[wurlycorner]

Never knew about that, but it's great that the original downpipe brackets can be put back to use now!

[newkid]

Never knew about that, but it's great that the original downpipe brackets can be put back to use now!

They don’t

This is a bracket fujitsubo give, connects to part 16 if I’ve read the diagram right. It’s obvious when your under the car.

.

Hope this helps.

[Vtecmec]

16 is a gearbox stay bracket, I think it's too low to fit at that point.

[newkid]

16 is a gearbox stay bracket, I think it's too low to fit at that point.

That’s it! Goes to the bolt that goes up the way. Mind the fujitsubo manifold is huge compared to oem. Runners go much further down.