More Power!!!

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Wed Feb 19, 2014 11:16 am

Pleased you're pleased with the purchase.

Everything you need to know about where to find the service connector and how to read codes is in the official service manual, which can be downloaded as a pdf from the wiki-lude section of the forum (see top title bar).

The airbag reset procedure is in the how-to section of the forum I think?

Post by **Merlin** » Wed Feb 19, 2014 11:25 am

SRS reset is in the Wiki as well

mercutio · Post by **mercutio** » Wed Feb 19, 2014 5:42 pm

make sure you use proper conductive wire not a paperclip when your doing the srs reset

Post by **derrick1988** » Wed Feb 19, 2014 8:30 pm

ok cool getting slave cylinder in and bleeding it next couple of days. conductive wire as in household appliance wire?

mercutio · Post by **mercutio** » Wed Feb 19, 2014 9:09 pm

like electrical wire some paperclips aren't conductive enough

Post by **derrick1988** » Thu Feb 20, 2014 12:00 pm

ok that's fine wasn't sure if it would of damaged electricals using paperclip.

Post by **derrick1988** » Thu Feb 20, 2014 4:47 pm

still having difficulty with location of srs but being 6 foot 4 it aint easy fitting into small areas! lol HOWEVER.... I pulled code 21 from 4ws which is rear sub and main angle sensor can these be reset (im hoping) or do I need to replace?

mercutio · Post by **mercutio** » Thu Feb 20, 2014 6:12 pm

under the dash by the steering wheel its a yellow wire that terminates in a plug blank

Post by **derrick1988** » Thu Feb 20, 2014 6:25 pm

cool ill check that out tomorrow evening mercutio. would there be any reason when resetting 4ws the light stays on when centering wheel first time round I tried it over ten times but light just wont go off for me to go clockwise again.

mercutio · Post by **mercutio** » Thu Feb 20, 2014 6:42 pm

not sure buddy I have never had to do the 4ws reset one of the others will be along to say something intelligible soon