Little bits for 4th (JAE?)

Post by **Vtecmec** » Fri Aug 29, 2014 7:27 pm

I'm after a few little bits (and one big one) if anyone has the following as is going to JAE?

About 10 interior dome headed screws
The little plastic clip that secures the bonnet stay (near the battery)
Rear boot trim (the one that covers the back panel and rear lights)

Cheers

Post by **Gayno** » Fri Aug 29, 2014 8:18 pm

Vtecmec wrote:The little plastic clip that secures the bonnet stay (near the battery)

Good luck with that!!

Post by **Vtecmec** » Fri Aug 29, 2014 8:22 pm

You never know, I was hoping mr @Wurlycorner may have one (or all)?

ludakris · Post by **ludakris** » Sat Aug 30, 2014 12:08 am

I have all the parts listed. Pm me if your still after them.

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Sat Aug 30, 2014 12:43 am

I can do all of those. But...

I have 4 rear screen bottom trims to choose from, none are at all 'mint' and some are downright shocking, but you're welcome to take your pick!

I think the bonnet stay on the breaker is knackered, but I'll try and get it off and bring it and you can make your mind up.

Post by **Vtecmec** » Sat Aug 30, 2014 8:25 am

wurlycorner wrote:I have 4 rear screen bottom trims to choose from, none are at all 'mint' and some are downright shocking, but you're welcome to take your pick!

That's ok, because that's not what I'm after.

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Sat Aug 30, 2014 11:05 am

that's what you get for reading and replying when jobby faced on the last train home

Is it just the hard plastic part of that boot trim you're after (that clips on the bottom lip between the lights) or the furry bit that runs the full width over the back of the lights as well?

Post by **Vtecmec** » Sat Aug 30, 2014 5:26 pm

Just the hard plastic but should do it thanks.

ludakris · Post by **ludakris** » Sat Aug 30, 2014 8:54 pm

Vtecmec wrote:Just the hard plastic but should do it thanks.

I also have one

Post by **Vtecmec** » Sat Aug 30, 2014 9:04 pm

Thanks Ludakris, but Wurlycorner has all the bits I need (for now anyway..........)