3G: Fogs not working

Post by **Wayne2014** » Sat Dec 06, 2014 10:49 am

Anyone know:

1. How to replace bulbs?
2. Remove fogs to check for wires/earth?
3. Do i need to remove bumper to gain access?

Thanks!

Post by **Wayne2014** » Sat Dec 06, 2014 10:49 am

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Sat Dec 06, 2014 11:06 am

Remove the front splash guards I expect (wheel arch liners)? Have a look in the service manual I suggest.
Beware, unless the bumper has been off recently, the clips that the bolts at the front screw into will be drokked and will probably mangle up the plastic, unless you're very careful.

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Sat Dec 06, 2014 11:08 am

Actually, that red connector you can see is for the fog light. If you have a multimeter, unplug that and you can check if the bulb is ok etc from there, without dismantling anything else.

Samiya85 · Post by **Samiya85** » Sat Dec 06, 2014 7:50 pm

U need to remove the front indicator as well as the side light u removed
Once u remove the amber indicator u see a 10mm or 12mm Bolt exactly across
Tht holds the whole fog lamp
Remove the bolt un plug wiring
U have the fog lamp in your hand.

Samiya85 · Post by **Samiya85** » Sat Dec 06, 2014 7:53 pm

Its the second bolt down holding the L bracket
Just seen the bolt on your 2nd pic u posted
But u have to remove front indicator to gain accses to it

Post by **Wayne2014** » Sat Dec 06, 2014 8:54 pm

Samiya85 wrote:U need to remove the front indicator as well as the side light u removed
Once u remove the amber indicator u see a 10mm or 12mm Bolt exactly across
Tht holds the whole fog lamp
Remove the bolt un plug wiring
U have the fog lamp in your hand.

Tis what i was thinking - but wasnt sure the front indicator would give me access.

But cheers - i will give it a go when have time!