abs fault

hondansxr · Post by **hondansxr** » Sat Aug 08, 2015 7:08 pm

so I got my old lude that's been parked up for @ 6 months and thought id try to get the 4ws working
fault code on 4ws is 20 .. front steering main sensor
abs is "3 2" front solenoid any ideas where this is .? cheers

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Sat Aug 08, 2015 9:49 pm

I think the main sensor is the one in the front steering rack. Check the service manual though and it's all explained in there.

Front solenoid must be in the main abs module, but again, if you check the service manual it will be confirmed in there. There are fault finding guides for each code.

They're not common codes to get tbh.

hondansxr · Post by **hondansxr** » Sun Aug 09, 2015 9:40 am

thanks for the reply
apart from a trip to donnington in2011 it has sat doing nothing for last 4 yrs wonder if this is contributing to solenoid

hondansxr · Post by **hondansxr** » Sun Aug 09, 2015 6:14 pm

changed the fluid in all the system clean all the slides and pads stripped front n/s caliper down as it was sticking now it shows the o/s up ? did the reset and it seems to have worked (abs)
got the 4ws to move as well but 1/2 miles down the road 4ws light came back on ???

did the steering wheel set up in car had the three pin plastic unit( sensor) behind the steering wheel at 12- 3 and 6 o clock .. going to track it up then reset steering wheel again see if that helps