4g half mast and switch works perfect £48 posted

preludemanh22 · Post by **preludemanh22** » Wed Feb 10, 2016 9:27 pm

half mast with switch works perfect

£48 posted

preludemanh22 · Post by **preludemanh22** » Mon Feb 15, 2016 12:12 pm

preludemanh22 · Post by **preludemanh22** » Thu Feb 18, 2016 4:39 pm

preludemanh22 · Post by **preludemanh22** » Sun Feb 21, 2016 12:49 pm

uberNoobZA · Post by **uberNoobZA** » Tue Feb 23, 2016 6:29 pm

ooo - just what I been looking for.

How easy it is to install this ?

preludemanh22 · Post by **preludemanh22** » Tue Feb 23, 2016 6:34 pm

Easy

uberNoobZA · Post by **uberNoobZA** » Tue Feb 23, 2016 6:40 pm

I know it's easy to isntall the Aerial (I already replaced mine as my car came with a crappy aftermarket one). How easy (I am a novice) to get the electrics all connected up correctly, as I don;t have an antenna switch on my dash.

uberNoobZA · Post by **uberNoobZA** » Tue Feb 23, 2016 6:56 pm

You know what, I'll take it. Please PM me and let me know payment details etc.

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Tue Feb 23, 2016 8:03 pm

Your UKDM doesn't have a switch because the half mast was only fitted to jdm models.

You can fit this to a UKDM and have 2 choices...
1. you can add the half mast switch, requiring extra wiring to be added between the cabin and the aerial in the boot.
2. You can fit the aerial and not worry about adding the half mast switch, but will need to change the connector in the boot anyway so that it plugs in and operates the mast to the correct height (UKDM plug is 2 pin iirc, whereas this has a 4pin plug although it only uses 3 pins, iirc).

uberNoobZA · Post by **uberNoobZA** » Tue Feb 23, 2016 8:11 pm

wurlycorner wrote:Your UKDM doesn't have a switch because the half mast was only fitted to jdm models.

You can fit this to a UKDM and have 2 choices...
1. you can add the half mast switch, requiring extra wiring to be added between the cabin and the aerial in the boot.
2. You can fit the aerial and not worry about adding the half mast switch, but will need to change the connector in the boot anyway so that it plugs in and operates the mast to the correct height (UKDM plug is 2 pin iirc, whereas this has a 4pin plug although it only uses 3 pins, iirc).

Thanks for the info. I found a couple of write-ups on Google as well, so will see if I can figure it out (no pictures though, and I'mn a pictures guy

). Do I simply need to run some wires fro mthe switch to the aerial in the boot, or does the switch need to be added to the wiring already going to the boot for the UKDM aerial ?