My 2 preludes in the netherlands bb9 and bb6 JDM type S

Post by **Thebusofwoe** » Thu Feb 25, 2016 9:08 pm

I was going to completely strip it and check/repair with new rings.

The "S" express · Post by **honda-hardy** » Thu Feb 25, 2016 9:18 pm

This engine did smoke on over run. However it still made 212.3 bhp on the dyno.

Dennis van dijk · Post by **Dennis van dijk** » Fri Feb 26, 2016 5:41 am

But this engine is never rebuild?

The company that should do my engine sayd

Mine cant be rebuild anymore because it has oversize bearings and iversize pistons

I have everything but only need block with crank rods and pistons

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Fri Feb 26, 2016 9:01 am

Drax has some A8 pistons for sale iirc.

Dennis van dijk · Post by **Dennis van dijk** » Fri Feb 26, 2016 6:21 pm

The block cant be bored again

Tomorrow i check the cilinders than i know for shure i need another block

Post by **RattyMcClelland** » Fri Feb 26, 2016 7:19 pm

Sleeve the block.

Dennis van dijk · Post by **Dennis van dijk** » Fri Feb 26, 2016 8:48 pm

I tought about that ratty

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Sun Feb 28, 2016 10:58 am

Much more expensive option. If the engine in staying standard (not going forced induction) then well OTT expense, IMO.

Dennis van dijk · Post by **Dennis van dijk** » Sun Feb 28, 2016 11:47 am

Im not going to boost

Just want the original engine

Or a same one with the atts

Just want to keep it original

Dont know yet what the prices would be here for sleeves

Post by **Thebusofwoe** » Sun Feb 28, 2016 8:38 pm

Let me know what you need/want. As i said, we could sort something out.

Lude Generation

My 2 preludes in the netherlands bb9 and bb6 JDM type S

Re: our 3 bb6 preludes in the netherlands

Re: our 3 bb6 preludes in the netherlands

Re: our 3 bb6 preludes in the netherlands

Re: our 3 bb6 preludes in the netherlands