got quite a bit done with the wire tuck;
fuse box done (apart from the battery and starter connections)
widow wiper wires tucked
most engine bay wires have been re routed from the bay, through the wing, and under the dash..
and a general tidy up
here are the pics of the section I had to cut out the dash to fit the fuse box from the other day.
used this wee gem of a dremel !
started off stripping all the wire organisers this morning
then started organising out the wires to reroute them
this is the unnecessary length of most of the wires !
then started to feed them into the car
ended up with this lot
wee took the bung for the window wiper from here..
to here, which is where most of the wired will be re routed to
started taping up the wiper wires with loom tape, amazing stuff and a MUST if your doing this sort of job !
got the wiper motor in and the wire tucked through the water drain.. its held up with a cable tie and its been water proofed
this is where is comes out
not sure where i want to move this to... so a question !
does anyone know if these NEED to be in the bay?
only reason i ask is because they have vacuum hosed and one has a weird wee filter
the bracket will be replaced with this
soldering some wires
and the end result for today
and the excess !
still alot to do in the inside, but thats the outside done
and as i was also working on donnas civic my garden looked like this by the end of the day lol
