Urgent 4g Rear Spindle Assembly o/s n/s

Post by **Vtecmec** » Wed Mar 11, 2015 1:20 pm

As the title, I am in need of a n/s and o/s rear spindle assembly of a 4th gen, it is the shaft that the hub sits on, must be an ABS model as it also has the mounting points for the sensor (unless the non ABS 4WS has these points too?).

Part numbers 10 and 11 here:

http://www.lingshondaparts.com/honda_ca ... k_03=22950

Here is a pic of the part in the middle:

Please don't ask why.

Post by **NafemanNathan** » Wed Mar 11, 2015 1:36 pm

Can't!... help... but... ask......

...Why?

Post by **Vtecmec** » Wed Mar 11, 2015 1:40 pm

I knew someone would.

Seems too much time in the rust removal soup also eats the metal away. I've just been doing some maintenance checks on the car and the rear bearings have a slight amount of play where they mount around the spindles.

Post by **NafemanNathan** » Wed Mar 11, 2015 2:01 pm

That is all

GJMHONDA2012 · Post by **GJMHONDA2012** » Wed Mar 11, 2015 2:04 pm

I have 2 rear hubs from my breaker car but not sure if it had abs or not cant remember

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Wed Mar 11, 2015 2:06 pm

If that's the one you sent me the rear dust shields from (the dinner plates behind the discs) then it didn't have ABS.

Post by **Vtecmec** » Wed Mar 11, 2015 2:20 pm

NafemanNathan wrote:

That is all

And there was I, showing noithing but compassion for Recarogate, whilst others have taken the body lemonade.

Post by **NafemanNathan** » Wed Mar 11, 2015 2:31 pm

GJMHONDA2012 · Post by **GJMHONDA2012** » Wed Mar 11, 2015 2:37 pm

wurlycorner wrote:If that's the one you sent me the rear dust shields from (the dinner plates behind the discs) then it didn't have ABS.

Yeah its the same one mate

Post by **Vtecmec** » Wed Mar 11, 2015 3:25 pm

I've sourced an o/s one, so now just need a n/s please.