Dexter - '86 AeroDeck

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Fri Oct 18, 2013 8:57 am

NafemanNathan wrote:Stace will be in, so I'll let her know, but just crack on. If the curtains are drawn it means she's not up

so much wrongness could be inferred...

Post by **NafemanNathan** » Fri Oct 18, 2013 9:14 am

But you're better than that aren't you Iain?

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Fri Oct 18, 2013 9:37 am

Oh absolutely! Damn right!

Monzta · Post by **Monzta** » Fri Oct 18, 2013 10:13 am

Monzta · Post by **Monzta** » Fri Oct 18, 2013 12:54 pm

NafemanNathan wrote:Glenn, my Aerodeck still hasn't gone if you still wanted to pop over to rob it of it's sunroof slider.

I managed to salvage a few useful parts today thanks Nathan. I didn't manage to get the sunroof slider out but I did get a few bits to replace ones that were broken and scruffy on my car. I did it just in time ... just as I was finishing up your neighbour turned up with his recovery truck. Phew!

Post by **NafemanNathan** » Fri Oct 18, 2013 1:02 pm

Glad you got some bits and bobs, shame you couldn't get the sunroof panel.

Was my neighbour definitely uplifting the Aerodeck? They're recovery breakdown guys, so on-call and therefore keep most of there vehicles at home. If it's a larger car transporter with a crane then the chances are they're finally taking the 'deck, as they don't keep that there.

Monzta · Post by **Monzta** » Fri Oct 18, 2013 2:05 pm

It was a proper big rig that turned up as I was leaving. They were going to move your Lude out of the way so they could get access to the Deck. The lorry was getting ready to reverse onto your drive as I drove away so best guess is they were going to crane it on to the back.

Post by **NafemanNathan** » Fri Oct 18, 2013 2:17 pm

Just got a text from Stace saying "Sorry, how much was Glenn taking?!", with this picture attached...

EDIT: For others, the Aerodeck was parked over the brown patch next to the lude

Monzta · Post by **Monzta** » Fri Oct 18, 2013 4:32 pm

NafemanNathan wrote:Just got a text from Stace saying "Sorry, how much was Glenn taking?!", with this picture attached...

Curses! I'm found out.

I was wearing my coat with the massive pockets.

Crazy_C · Post by **Crazy_C** » Fri Oct 18, 2013 8:56 pm

Monzta wrote:Curses! I'm found out.

I was wearing my coat with the massive pockets.

So the scrappy visiting coat then?

I've snuck a rad out of a scrappy before under a trench coat

I'm on my phone at the moment, so can't upload a photo, but I got rid of about 4 foot of intake pipe work. I had a similar issue with it drawing in hot air as the pipe work runs behind the block!!!

As for the clutch, just adjust it. There's an adjuster knob just above and I front of the gearbox. I snapped a clutch cable, and when I put the new one on, the clutch was too low for my liking so I just adjusted it slightly, but it works both ways. Might help till you get the clutch done.

Lude Generation

Dexter - '86 AeroDeck

Re: Dexter - '86 AeroDeck

Re: Dexter - '86 AeroDeck

Re: Dexter - '86 AeroDeck

Re: Dexter - '86 AeroDeck